Accuquilt GO! Cornucopia-10" Finished Die

AQ Cutting Mat Required: 55206

For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller. Tip: The die is specially designed to cut one complete 5-color 10" block in one pass through the cutter.

• Fabric Color 1: For 3 A shapes: Cut three 6" x 3 1/8" rectangles. Place right side up over shape A to cut.
• Fabric Color 2: For 3 A shapes: Cut three 6" x 3 1/8" rectangles. Place right side up over shape A to cut.
• Fabric Color 3: For 1 B shape: Cut one 5 1/4" x 6" rectangle. Place right side up over shape B to cut.
• Fabric Color 4: For 5 E shapes: Cut five 2 1/2" squares. Place right side up over shape E to cut.
• Fabric Color 5: For 2 C, 2 ea. D/DR & 6 F shapes: Cut 12 1/8" x 8 1/2" rectangle. Fanfold in half and place over shapes C/D/DR/F to cut

Why Quilters Love the GO! Cornucopia Die:

• Cornucopia is a Block on Board® (BOB®) die which means it’s specially designed to cut one 5-color, 10" block in one pass through the cutter.
• No templates! No special rulers! Cornucopia includes 9 shapes that are time-consuming to cut by hand.
• Cornucopia features specialized dog-ears and ¼" seam allowances for easy alignment and piecing.
• Cornucopia includes screen-printed letters on die for easier piecing and organization of shapes.
• Free pattern downloads and step-by-step block assembly instructions are available to get you started.
• Fat Quarter-friendly
• Do you EQ? If you have Electric Quilt® software, you can use it to create your own Cornucopia designs from their block library and cut your fabric

AccuQuilt Benefits: 

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

Die Tips: 

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.