Accuquilt Go Lucky Star Die 10" finished

AQ Cutting Mat Required: 55206

How to Die Cut 4-Color Lucky Star Blocks:For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller. Tip: The die is specially designed to cut one complete 4-color 10" block in one pass through the cutter.

• Fabric Color 1: Cut A, B, and C together. Cut four 8 1/4" x 5 1/2"rectangles. Place right side up over shapes A, B, and C to cut.
• Fabric Color 2: Cut D and E together. Cut four 3" x 3 3/4"rectangles. Place right side up over shapes D and E to cut.
• Fabric Color 3: Cut F and G together. Cut four 5 5/8" x 3 1/4"rectangles. Place right side up over shapes F and G to cut.
• Fabric Color 4: Cut four 6" x 3 1/2" rectangles. Place right side up over shape H to cut.

• The new GO! Lucky Star Block on Board® die makes creating scrappy star blocks quick and easy! This traditional quilt block finishes to 10" and is very versatile, you can make a full-size lucky Star quilt for any occasion or add a simple border to one block for a unique pillow.
• Lucky Star is a Block on Board® (BOB®) die which means it's specially designed to cut one 4-color, 10" block in one pass through the cutter.
• No templates! No special rulers! Lucky Star includes 9 shapes that are time-consuming to cut by hand.
• Lucky Star features specialized dog ears and ¼" seam allowances for easy alignment and piecing.
• Lucky Star includes screen-printed letters on the die for easier piecing and organization of shapes.
• Free pattern downloads and step-by-step block assembly instructions are available to get you started.
• Fat Quarter-friendly
• Do you EQ? If you have Electric Quilt® software, you can use it to create your own Lucky Star designs from their block library and cut your fabric.

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.