Accuquilt GO! Washington's Puzzle-4" Finished Die

AQ Cutting Mat Required: 55204

How to Die Cut 3-Color Washington’s Puzzle Blocks:For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller. Tip: The die is specially designed to cut three complete 3-color 4" finished blocks in one pass through the cutter

• Fabric Color 1: Cut three 3-1/2" squares. Place right side up over shape A to cut three shapes.
• Fabric Color 2: Cut six 3-1/4" squares. Place right side up over shapes B to cut 12 shapes. Do not fanfold.
• Fabric Color 3: Cut six 3-3/4" x 5" rectangles. Place right side up over shapes C to cut 12 shapes. Do not fanfold.

• The new GO! Washington’s Puzzle Block on Board® die is our first 4” finished Block on Board die!
• Washington’s Puzzle is a Block on Board® (BOB®) die which means it’s specially designed to cut three 3-color, 4" finished blocks in one pass through the cutter.
• No templates! No special rulers! Washington’s Puzzle includes 5 shapes that are time-consuming to cut by hand.
• Washington’s Puzzle features specialized dog-ears, 1/4" seam allowances, and notches for easy alignment and piecing.
• Washington’s Puzzle includes screen-printed letters on die for easier piecing and organization of shapes.
• Free pattern downloads and step-by-step block assembly instructions are available to get you started.
• Fat Quarter-friendly
• Do you EQ? If you have Electric Quilt®software, you can use it to create your own Washington’s Puzzle designs from their block library and cut your fabric.

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.