Accuquilt GO! Mushroom Medley Die by Janine Lecour

AQ Cutting Mat Required: GO! Cutting Mat, 6 in. x 12 in. (15.2 cm x 30.4 cm)

• Large Cap: Cut and fuse one 5 5/8" x 3" rectangle. Place on selected blade and cut. Cut 13 large caps across the width of fabric. One yard of 40" wide fabric cuts 78 large caps.
• Large Gills: Cut and fuse one 5 1/8" x 1 5/8" rectangle. Place on selected blade and cut. Cut 24 large gills across the width of fabric. One yard of 40" wide fabric cuts 168 large gills.
• Large Stalk: Cut and fuse one 2 3/4" x 4 5/8" rectangle. Place on selected blade and cut. Cut 8 large stalks across the width of fabric. One yard of 40" wide fabric cuts 104 large stalks.
• Small Cap, Stalk & Circles: Place scraps on blade and cut.

• Janine Lecour is a digital pattern designer who loves to design vibrantly colored, exuberant patterns to create a whimsical art experience.
• Create a forest of fungi in a flash with the GO! Mushroom Medley die by Janine Lecour, the perfect addition for all kinds of projects.
• No templates required. The GO! Mushroom Medley die includes seven applique shapes that are typically difficult to cut by hand.
• Quickly and easily cut four of each pre-fused applique shapes in one pass through the cutter (fusible counts as one half layer of fabric).
• Cut mushroom shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics, and more!
• A great way to use up scraps.
• Includes free embroidery download with 3 stitches ($22 value).
• Free pattern downloads available to get you started.
• Fat Quarter-friendly

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.