Accuquilt GO! Baby Bib Die

AQ Cutting Mat Required: 55205

How to Die Cut Baby Bibs:For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller.TIP: The die is designed to cut three complete baby bibs in one pass through the cutter. 

• For each color: Cut 1—13” x width of fabric (WOF) strip. Position nap to bottom of bib on die.  (Cuddle® fabric is 60” wide.) Fanfold to 8 1/2” on die.  Sub cut into 6 baby bibs—3 right facing and 3 left facing.

• Due to popular demand, the GO! Baby Bib die is now available in both GO! And Studio. 
• If you need a baby gift or just want an easy sewing project, this baby bib pattern can be cut in minutes and sewn quickly and easily!
• GO! Baby Bib is a DIY (“do-it-yourself”) Project die.  These are popular shapes of projects that you make for yourself, to give as gifts or to sell. 
• No template required.  The GO! Baby Bib die includes a standard-sized baby bib shape that is typically difficult to cut by hand. 
• Quickly and easily cut 3 complete baby bibs in one pass thru the cutter (2 cuts needed per baby bib).
• Make baby bibs out of a variety of fabrics cut with your GO! Baby Bib die: flannel, terry cloth, waffle fabric, Cuddle® fabrics, cotton and more!
• Make it personal! GO! Baby Bib is designed to work with GO! Applique shapes that are 5” or smaller or embellishing with embroidery.
• Packaging includes a free pattern to get you started. 
• Fat Quarter Friendly

• Cut so much more fabric in less time. 
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut. 
• Safe to use -- No blades come anywhere near your fingers

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors. 
• Blades on some dies are positioned at an angle.  Align fabric to edge of shape, not edge of die board. 
• Use good quality fabric to reduce fabric stretch. 
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.