AccuQuilt GO! Daisy Die

Cut Size: Large Petal: 5/8"W x 2 1/4"H (1.6 cm x 5.7 cm), Small Petal: 1/2"W x 1 3/4"H (1.3 cm x 4.4 cm), Large Center: 1 1/4" (3.2 cm), Small Center: 3/4"W (1.9 cm)

Finished Size: Large Flower: 4 1/2" (11.4 cm), Small Flower 3 7/16" (8.7 cm)

AQ Cutting Mat Required: 55139

How to Die Cut Daisy Shapes:Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.

Large Petal: Cut and fuse 2 3/4" x 2 7/8" rectangles. Cut 44 large petals across the width of fabric. One yard of 40" wide fabric cuts 572 large petals.
Small Petal: Cut and fuse 2 1/4" x 2 5/8" rectangles. Cut 60 small petals across the width of fabric. One yard of 40" wide fabric cuts 960 small petals.
Large Center: Cut and fuse 1 3/4" squares. Cut 22 large circles across the width of fabric. One yard of 40" wide fabric cuts 440 large circles.
Small Center: Place scraps on blade and cut.

Why Quilters Love the GO! Daisy Die:

The GO! Daisy die cuts four large petals, four small petals and two centers, providing unlimited options for adding fun flowers to any project from quilt tops to table runners.
No templates required. The GO! Daisy die includes three shapes that are typically difficult to cut by hand.
Mix and match the petals and centers to create a variety of flowers or use with other GO! floral dies to custom design your own quilted garden.
Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric).
Cut flower shapes out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
A great way to use up scraps.
Free pattern downloads available to get you started.
Charm Pack-friendly.

AccuQuilt Benefits:

Cut so much more fabric in less time.
Get accurate cuts every time -- No slipping rulers or mistakes
Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
Safe to use -- No blades come anywhere near your fingers

Die Tips:

With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
Use good quality fabric to reduce fabric stretch.
It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.

AccuQuilt GO! Daisy Die

Site Links

Contact Us